Forum Discussion

munish_64882's avatar
munish_64882
Icon for Nimbostratus rankNimbostratus
Aug 13, 2012

access lost when click force standby

Hi All,     I am new to F5 technology.. so I am not aware if its a common behaviour of F5.     1. I have configured my Load Balancers to work in Active/standby state. but both the devices ...
basic
getting started
new to f5
nitass's avatar
nitass
Icon for Employee rankEmployee
Aug 14, 2012
is unicast address for network failover setting correct?

 

 

Specifying unicast addresses for failover

 

When specifying unicast, rather than multicast, addresses for failover, you need to specify two pairs of IP addresses, where one of the pairs indicates the management IP addresses of the two units. The other pair indicates two self IP addresses, one for VLAN HA on each unit.

 

Configuring High Availability

 

http://support.f5.com/kb/en-us/products/big-ip_ltm/manuals/product/tmos_management_guide_10_1/tmos_high_avail.html1051950