Forum Discussion

kldev_132889's avatar
kldev_132889
Icon for Nimbostratus rankNimbostratus
Sep 03, 2013

Automap SNAT with Multiple VIPs

I want to create two VIPS on our F5 and setup two inbound AutoMaps on each VIP. The automaps would both translate the same specific inbound address to the floating IP associated with the appropriate ...
BIG-IP Access Policy Manager (APM)
design
security
nitass's avatar
nitass
Icon for Employee rankEmployee

i understand you have snat list with specific source address, haven't you?

 

have you tried to set snat none under virtual server configuration? when traffic hits the virtual server, since the virtual server's snat is set to none, snat list would apply to the traffic.

 

kldev_132889's avatar
kldev_132889
Icon for Nimbostratus rankNimbostratus
Sep 04, 2013
I want to SNAT only specific traffic passing through the VIP. I was thinking I needed to set up a SNAT list with the translation set to Automap and apply that to each VIP. However, per what your saying I think I am making this to difficult and if I just set up the SNAT list instead of what I was trying to do, all of my specific source addresses coming in through each VIP will be translated to the correct floating IP associated with the outside interface it should route out of? And the rest of my addresses will remain un-translated that are not specified in the address list?