Forum Discussion
insomniak_11745
Oct 22, 2014Nimbostratus
It was all a bit chaotic, to be perfectly honest. I eventually was able to successfully fail over to the upgraded 11.6 standby unit.
I then upgraded the 11.3 unit to 11.6 successfully. After which I failed back to the primary unit, and this happened again but I was unable to recover from it. I eventually booted the standby device back to 11.3 while it was in an active state and it returned to normal.
I understand that my panic could very well have been some of the cause for this, but that log snippet is from immediately after I forced a failover.
I did not have mac masquerade configured.