Forum Discussion

Cisco2F5_16233's avatar
Cisco2F5_16233
Icon for Nimbostratus rankNimbostratus
Jul 09, 2013

F5 Sync between two different models

So My Company is try to come with a "cost effective" DR strategy and the question was asked...could I take say an 8400 and sync with a 8900 ? From what I know…     If they have the same code,...
config
design
nitass's avatar
nitass
Icon for Employee rankEmployee
Jul 11, 2013
11.4.0 introduces load-aware failover, so i understand different hardware is supported.

 

 

Load-aware failover for Sync-Failover device groups

 

 

Prior to failover, the device that the BIG-IP system chooses as the target failover (next-active) device is now based on a combination of device capacity and application traffic load. The BIG-IP system performs continual calculations to determine the device that has the most available resources, based on capacity and traffic load, and then, for each device, identifies its next-active device accordingly. This feature is most useful when the device group contains heterogeneous hardware platforms.Release Note: BIG-IP LTM and TMOS 11.4.0

 

http://support.f5.com/kb/en-us/products/big-ip_ltm/releasenotes/product/relnote-ltm-11-4-0.html