Forum Discussion
Emre_Ovali_1466
Cirrus
Hi Michael,
There is another and easy way to change the subnet mask of a self IP address.
So,
/config/bigip_base.conf
is the configuration file which includes the networking components of the device.
When you open this file with an editor like "vi" , you should see the Ip address configuration of a specific IP like this.
net self /Common/192.168.10.2 {
address 192.168.10.2/24
traffic-group /Common/traffic-group-local-only
vlan /Common/Vlan328
}
Then, what you need to do is only to change the related subnet mask fields with the new one and save the file.
Finally, run the command
tmsh load sys config
Emre_Ovali_1466
Feb 02, 2018Cirrus
Do you remember what you changed in the configuration file? I offered this as a solution, because it should be pretty easier to change only 2 numbers in a file for an F5 administrator. I would not be commented about your problem without knowing what you changed in this file. I agree with you if a more detailed change was needed.