Forum Discussion
Aabuitrago
Altostratus
Hi,
How do you configure the vservers for each port 500 and 4500. I saw on the blog that this vservers does not use SNAT. Should i configure the F5 as gateways of the Servers of the pool?
regards,
Fallout1984
Jul 28, 2021Cirrocumulus
I've read that if not using SNAT, then set the backend servers to use the F5 as the default gateway. That was in the comments section below the "Always On VPN IKEv2 Load Balancing with F5 BIG-IP" article on Richard M. Hicks's site. I've been asked about doing this, so I'm starting to learn about it as well.
- mbrandon32Dec 01, 2021Cirrus
How are you IP'ing your backend servers? Single NIC on the F5 network? Or dual NICs - one on AOVPN network and one on F5 network?