Node UP and Node Down messages do not get written

That is also set to "notice"

 

We understand about the remote syslog, but since it was the only way to get it working we know we need to change it when we cycle.

 

 

It's not been rebooted, I suppose we should plan a reboot over the holidays but it's heavily used 24/7 - before it went to prod we tested this and say only a 7 second outage when the secondary took over but it's still nerve racking to do this at anytime!

 

 

Ideally we can figure out what's wrong without needing the reboot? :)