Forum Discussion

hung_105573's avatar
hung_105573
Icon for Nimbostratus rankNimbostratus
Oct 31, 2012

Can not reset factory default F5

Hi all

 

when i run command : save sys config then get errors:

 

Unexpected error: Configuration cannot be saved unless mcpd is in the running phase.Save was canceled.See " show sys mcp " and "show sys service" .If "show sys service " indicates that mcpd is in the run state , but "show sys mco " is not in phase running ,issue the command "load sys config " to further diagnose the problem.

 

when i run command : load sys config then get errors :

 

0107100f:3: the Provisionning for module (em) is invalid or cannot be used on this platform.

 

when i run command : load sys config default then get errors : MCP must be in the running phase to reset the trust domain .Examine the output of tmsh show sys mcp-state for failures.

 

i save MCPd is running in status service.

 

pls help me . reset factory default it .

 

thank all

 

 

4 Replies

  • can you try to delete provision em in configuration file and then run tmsh load sys config again?

     

     

    in v10, provision could be in /config/bigip_sys.conf

     

    in v11, it could be in /config/bigip_base.conf
  • Hi Nitass

     

     

    My F5 ( demo license LC and LTM) , when i update new license for it then F5 have reload ? the system network will operator normal in process update ?

     

     

    pls help

     

     

    thanks

     

     

     

  • Hi Nitass

     

     

    My F5 ( demo license LC and LTM) , when i update new license for it then F5 have reload ? the system network will operator normal in process update ?

     

     

    pls help

     

     

    thanks

     

     

     

  • i understand activating license requires configuration to be reloaded which will of course interrupt traffic for a while.