Forum Discussion
12 Replies
- What_Lies_Bene1Cirrostratus
Again, please read this article: http://support.f5.com/kb/en-us/products/big-ip_ltm/manuals/product/bigip-upgrade-active-standby-11-2-0.html?sr=25267357
The only thing to keep in mind appears to be this: "Assigning a single BIG-IP system to probe a server to gather health and performance data, in version 10.x, is replaced by a Prober pool in version 11.x."
- sanz_87139NimbostratusI do have a quick question should we change anything in GTM when we upgrade ltm
- What_Lies_Bene1CirrostratusLooks like the only thing is what I listed above, Probes become Prober Pools in v11; I'm not sure how you'd deal with this in advance I'm afraid.
- sanz_87139Nimbostratusnope I am good I will deal it and let you you know...........
- What_Lies_Bene1CirrostratusOK, good luck. Hope it goes well.
- sanz_87139Nimbostratus
hey hi I am having one doubt regarding the irules when we upgrade the version of ltm will there will be any issues with the irules
- What_Lies_Bene1CirrostratusI don't think you are likely to have any issues (unlike v9 to v10) unless you are using APM too. Of course, test thoroughly. Remember, you'll upgrade the standby and use a different volume to the current one so you can roll back very easily. Make sure you have an off-device UCS too.
- sanz_87139Nimbostratus
ok thanq a lot
- EmBee_57573Nimbostratus
Can you tell me if you had any issues when the LTM's were upgraded? We have LTM and GTM running V10 and want to upgrade the LTM to 11.3
- sam_travis_8103Nimbostratus
Unless you have days on hand to reconfigure your boxes, then there is no issue. I have LTM 10.2.3 and tried to upgrade to 11.x four times and the same result every time. It doesn't work. The configuration doesn't carry over and load. Then any external script needs to be reloaded and then once that's done, the entire configuration needs to be re-written from scratch. In addition, all HA configuration needs to be re-thought of and re-written.