Forum Discussion
7 Replies
Sort By
- What_Lies_Bene1CirrostratusYou can use these at the VMWare console to configure the management interface (eth0 in the CLI);
- vishal_124938NimbostratusHi Steve,
- What_Lies_Bene1CirrostratusApologies Vishal, I didn't spot you'd posted this in the iControl forum! Unfortunately I've no clue where iControl is concerned. Hopefully someone else can help you out here.
- vishal_124938NimbostratusThanks a lot Steve. Updating Ip is my requirement.
- omniplexNimbostratusAre you looking for Management::Device::set_management_address?
- RaghavendracharNimbostratusCan i set all interfaces as management -interface , so that i can access UI from any available network ? if so please share how to configure it
- TeeraratCirrus
Hi, if you can access cli try to using command config fo rconfiguration ip management l.