Forum Discussion

BJ_114988's avatar
BJ_114988
Icon for Nimbostratus rankNimbostratus
May 25, 2015

my f5 is showing sync recommended message (on both active and standby), but i havent done any changes to it.how to troubleshoot?

my f5 is showing sync recommended message (on both active and standby), but i havent done any changes to it.how to troubleshoot? how to see what changes have been made or what changed?

 

5 Replies

  • Hopefully you have auditing turned on and can check the audit logs. They are located at /var/log/audit or audit.1.gz, audit.2.gz, etc. Otherwise you can look at the dashboard (if you are running I think 11.4 or later) and change the time to month. The little red balls at the bottom with designate days with changes and what was changed.

     

    • BJ_114988's avatar
      BJ_114988
      Icon for Nimbostratus rankNimbostratus
      thanks Steve! . unfortunately I am using 10.2.4 version
    • boneyard's avatar
      boneyard
      Icon for MVP rankMVP
      so still the audit logs can be useful. but personally i have seen this too often without a good cause. if you are sure nothing change just sync the units.
    • Steve_M__153836's avatar
      Steve_M__153836
      Icon for Nimbostratus rankNimbostratus
      Agreed. Also there are some locations within the GUI that will generate a "change" even if you don't change anything. Especially in v10.2.x. These locations include the config menus for SNMP, Remote Logging, DNS, NTP, and I think there are more. Could have just been the version/hotfix I was on, but as soon as I entered one of those menus when I was running 10.2.2 it would pop to 'Changes Pending.'