Forum Discussion

Adam_187298's avatar
Adam_187298
Icon for Nimbostratus rankNimbostratus
Nov 26, 2016

Upgrade from v10.2.4 to v12.0.0, no configuration migrates across

Hi. I want to upgrade an LTM-VE running v10.2.4 HF10 to v12.0.0 so I install the v12.0.0 image onto an available HDD and boot into that HDD, but none of the configuration is present when the system boots into v12.0.0 - no nodes, no pools, no virtual servers, no monitors, no iRules. The network configuration migrates across but nothing else. I have relicensed the v12.0.0 instance with the new license code successfully. If I then reboot back into v10.2.4, the configuration is present again.

 

I have performed two other LTM-VE upgrades successfully without issues, just this one is causing issues. We use a partition other than Common and I have noticed that the other two units have specific bigip.conf files in the respective /config/partitions/ directory but this unit does not have one - this is confirmed in the QKView upload

 

Does anyone have any ideas please?

 

application delivery
BIG-IP
LTM

1 Reply

Sort By
  • Niels_van_Sluis's avatar
    Niels_van_Sluis
    Icon for MVP rankMVP
    Nov 26, 2016

    Did you use the 'Install Configuration' option and selected the right volume to import and convert the configuration from when using the boot location? See:

    You can also check the liveinstall.log at: /var/log/liveinstall.log for warning/errors during upgrade. And check if the configuration is fully loaded:

    tmsh show sys mcp-state

    If the configuration is not fully loaded, check why:

    tmsh load sys config