Forum Discussion

jaikumar_f5_226's avatar
jaikumar_f5_226
Icon for Nimbostratus rankNimbostratus
Apr 19, 2017

MCPD log level explanation

Hey Folks,

I was quite searching multiple articles to see what these values changes mean ? But not much luck

(tmos) modify sys db log.mcpd.level value
Values:
  alert     crit      debug     emerg     err       error     info      notice    panic     warn      warning

From the Article I could know what is the default value (notice)

Also the below db change would help in getting GUI logging's right. Is it just restricted to GUI logging's are does it also effect other configuration changes too of cli.

(tmos) modify sys db config.auditing value
Values:
  all       disable   enable    verbose

Would combining both the above mentioned DB variables, what would be the effect. Please advise.

BIG-IP
security

2 Replies

Sort By
  • Ed_Summers's avatar
    Ed_Summers
    Icon for Nimbostratus rankNimbostratus
    Apr 20, 2017

    I may not entirely understand your question. Let me know if this doesn't help.

     

    For your first question - those options (alert, crit, notice, etc..) for the most part are standard syslog severity levels. See the syslog Wikipedia page for some general info. The levels themselves are just guidelines and applications map their specific errors to each level based on how severe the app's specific error is. F5 recently released a Log Messages List, but I am not aware of any reference that maps specific error messages to severity level.

     

    Audit logging does cover config changes through the GUI and CLI. It also includes some system-level (non-user) config change events.

     

    I'm not sure what you mean by combining those config changes. Basically each one allows you to control the level of logging for that function. Increasing audit logging would increase the granularity of config auditing, and decreasing the severity level (i.e. going down to DEBUG, for example) of mcpd logging would increase the logging of that system. Just be very careful of maximizing logging (using 'debug' or 'verbose' for example) as this can greatly increase the amount of logging and impact system performance. That's a general caution for any system.

     

    Does that help or are you trying to capture some specific information?