Kill "Setup Wizard" from CLI
Hello guys!
On a fresh install of BIG-IP, when you first log into the GUI you're presented with the "Setup Wizard". I'm setting my BIG-IP up through CLI following KB13369.
Everything worked just fine BUT after I finished the setup through the CLI, on the GUI I'm still getting "Setup Wizard" instead of the normal menus (Statistics, iApp, Local Traffic, etc).
I know I can finish it by clicking on Network --> Finished. I want to kill this setup wizard on the GUI through some CLI command/flag.
Is that possible?
Greetings,
This seems like a sys global-setting. I took a quick peek and noticed this:
modify sys global-settings
gui-setup
Enables or disables the Setup utility in the browser-based Configuration utility. The default value is enabled. Note that when you configure a system using the command line interface, you should disable this option. Disabling the gui setup option of the system command allows your system administrators to use the browser-based Configuration utility without having to run the Setup Utility.
Might do the trick, but I'm not sure the overall affect this might have. I'd be really sure to double-check your DSC settings if you use this and plan to have a high-availability configuration.
Good luck!
Kevin