Forum Discussion

Angelo's avatar
Angelo
Icon for Nimbostratus rankNimbostratus
Nov 13, 2012

File share and print traffic

Hi

 

I'm not sure how to go about this. load balacing file share and printer traffic. the fileshare part is a point to point one VIP one backend server. the printer traffic will go to two backend print server. everything is setup but nothing is working i'm not sure how to get this working. i checked a manual that said i should create a app tunnel but i'm using V11 and all the menus have changed in there...

 

application delivery
dev
devops
iRules

3 Replies

Sort By
  • What_Lies_Bene1's avatar
    What_Lies_Bene1
    Icon for Cirrostratus rankCirrostratus
    Nov 13, 2012
    Regarding the printer side, Hoolio just posted this for another post;

     

     

    "Here's an older post discussing Win2003 printer load balancing:

     

     

    https://devcentral.f5.com/community/groupdetails/tabid/1082223/aft/29211/asg/62/default.aspx56258"

     

     

    Does it help?

     

  • Angelo's avatar
    Angelo
    Icon for Nimbostratus rankNimbostratus
    Nov 14, 2012
    Hi

     

     

    I created a Iapp profile as it says in the post but i cannot connect to the VIP on the port this is what i get on a port scan..

     

     

    Interesting ports on sw_dr.tm.mtn.co.za (10.217.235.80):

     

    Not shown: 1679 closed ports

     

    PORT STATE SERVICE

     

    515/tcp filtered printer

     

     

    Nmap finished: 1 IP address (1 host up) scanned in 1.284 seconds

     

  • What_Lies_Bene1's avatar
    What_Lies_Bene1
    Icon for Cirrostratus rankCirrostratus
    Nov 14, 2012
    Isn't that the relevant/correct port? I didn't see any mention of iApps in the other posts.

     

     

    If I've understood the other posts correctly, you need a wildcard (for the port, not the IP address) Performance (L4) Virtual Server configured with Port and Address Translation disabled and a FastL4 Profile with loose close enabled etc. Your servers should have a loopback interface configured with the IP address of this Virtual Server and a route back to the clients that isn't through the F5. Is that what you've done?