Forum Discussion

VFB's avatar
VFB
Icon for Cirrus rankCirrus
Mar 19, 2017

GTM's will not auto update new WIPS

I'm currently setting up a pair of GTM's that are already sync'd as LTM's. I verified both are running the same version of big3d and can run the "gtm_add" command from one device to the other. Sync and sync dos zone files are checked. I added a NTP server so both system clocks are the same, but for some reason, when I add a WIP after the initial setup, it doesn't copy to the 2nd device. I'm running 11.6. Below is an output from the primary GTM to the secondary:

 

[root@bigip1-11:Active:In Sync] config iqdump 10.10.3.253

 

11.6.0 big3d Version 11.6.0.0.0.401 linux

 

8506 5155 3351 1292369 547623 744746 0 10687 1 0 notice 0 0 0 0

 

8518 5163 3355 1293025 548055 744970 0 10697 1 0 notice 0 0 0 0

 

application delivery
BIG-IP DNS

5 Replies

Sort By
  • VFB's avatar
    VFB
    Icon for Cirrus rankCirrus
    Mar 19, 2017

    I did notice that when I ran my command "netstat -anp | grep big3d", nothing shows up in the table as established via port 4353

     

  • Vijay_E's avatar
    Vijay_E
    Icon for Cirrus rankCirrus
    Mar 19, 2017

    Do you see any error logs - /var/log/gtm ?

     

    Did you go through this knowledge article - K13690 ?

     

  • VFB's avatar
    VFB
    Icon for Cirrus rankCirrus
    Mar 19, 2017

    No errors. When I run the script, it adds the GTM and even gets the most recent data on it, but doesn't accept any updates. I only see the connection for iquery in my initial script run via tcpdump. My netstat output doesn't show the connections to each other via 4353.

     

  • BigD_300005's avatar
    BigD_300005
    Icon for Cirrostratus rankCirrostratus
    Mar 20, 2017

    Verify your servers have been created. GSLB > Servers > Server List I had a similar issue and it would not sync until I did this.

     

    • VFB's avatar
      VFB
      Icon for Cirrus rankCirrus
      Mar 20, 2017

      It worked! I wished this was posted in the KB. Thanks much