HTTP monitor shows nodes unknown(enabled)
Hello, I am using the 90 day evaluation license and am just learning the device and am running into some issue. I have created 3 web servers and have them connecting via internal VLAN. I have created a health monitor in a pool using http but the web servers show offline. If I use gateway_icmp or create a monitor using http, get/ http/1.1, I show the pool is available. I can connect to each webserver via its IP address and get the webpage displayed in the browser. If I create a virtual server using service port 80, I show it is available (enabled under status. I can ping the address of the virtual server from my PC, but if I try a web browser port 80 to the address, I get web page is not available. I have tried turning off the firewall and antivirus with no success. I am lost at this point and if anyone has any suggestions, I would appreciate it. Thanks.
forwarding virtual server, with a port range?
Hi, I have used forwarding virtual servers in various ways but i have a reqt to forward traffic with a port range. For example, traffic will be going to a network destination but will be requesting a port in the range of 10000-12000. No i do not like this either, but that's what 'they' want... I don't want to do a wildcard port as i only want the specified range. Is there a way to achieve this? Thanks Jon
