Forum Discussion
I appreciate your feedback. I was told by the customer to do a physical separation, which as you said is not required by PCI. It all comes down to an extra check for the non-technical paper pusher.
Right now I have the following physical setup:
F5A - port 2.1 and 2.2 connected to 9KA port e1/5 e1/6 F5A - port 2.3 and 2.4 connected to 9KB port e1/5 e1/6 ---------------------(PCI vPC - A)---------------------------
F5A - port 2.5 and 2.6 connected to 9KA port e1/9 e1/10 F5A - port 2.7 and 2.8 connected to 9KB port e1/9 e1/10 ---------------------(non-PCI vPC - A)---------------------------
F5B - port 2.1 and 2.1 connected to 9KA port e1/7 e1/8 F5B - port 2.3 and 2.4 connected to 9KB port e1/7 e1/8 ---------------------(PCI vPC - B)---------------------------
F5B - port 2.5 and 2.6 connected to 9KA port e1/11 e1/12 F5B - port 2.7 and 2.8 connected to 9KB port e1/11 e1/12 ---------------------(non-PCI vPC - B)---------------------------
This will be a one arm setup. The only thing is that I only have done one vPC per each F5 one arm setup. I have never done 2 vPC setups pear each F5. Is there something special that needs to be configured.