milli-voltage () is too low ,Power supply failure

Question

Hi,
I am getting the following message on the display.&nbsp;
milli-voltage () is too low   ,Power supply failure &nbsp;
But I can see the following outputs
 Chassis Power Supply Status
 Index  Status           Current
 1      up               AC
 2      up               AC &nbsp;
Chassis Fan Status 
  Index  Status  Low Limit(rpm)  Fan Speed(rpm) 
  1      up      1000            12200 
  2      up      1000            12000 
  3      up      1000            12200 
  4      up      1000            12000 &nbsp;
Accroiding to F5 document,it says
  Description:This message occurs when one of the following conditions is met: 
                        External power to the PSU is lost. 
                        Input power readings are out of the recommended range. &nbsp;
What is the solution?Any clue??
Thank You&nbsp;

raghavendrasy_7 · Answer

Please refer and check whether your device model is mentioned in below article.&nbsp;
https://support.f5.com/csp/article/K17356&nbsp;

raghavendrasy · Answer

Please refer and check whether your device model is mentioned in below article.&nbsp;
https://support.f5.com/csp/article/K17356&nbsp;

raghavendrasy · Answer

You can verify the below article.&nbsp;
https://support.f5.com/csp/article/K38417018&nbsp;
Suggest you to open a ticket with the f5 vendor.&nbsp;

raghavendrasy_7 · Answer

You can verify the below article.&nbsp;
https://support.f5.com/csp/article/K38417018&nbsp;
Suggest you to open a ticket with the f5 vendor.&nbsp;

sena_291474 · Answer

Thanks a lot for the quick response.But unfortunately,my device not in the listed category.&nbsp;

Forum Discussion

milli-voltage (<voltage>) is too low ,Power supply failure </voltage>

8 Replies

Recent Discussions

Content type hearder charset=UTF-8

Web acceleration

Create a CSR and Key using the BigIP LTM GUI when renewing a certificate

Enterprise Security best practices with F5 WAF

Disk space full - what files, folders are safe to delete?

Related Content

Redundant power supply logs

Recieving logs of redundant power supply issue

Re: iRule to trigger email for captured logs