Forum Discussion
Brad_Parker_139
Dec 08, 2015Nacreous
Check your http and https monitors. There's a bug where when upgrading to 11.6.0 HF6 all the backslashes get escaped with another backslash in the http/s monitors which causes monitors to fail. You'll see stuff like
\\r\\n
when your expecting it to be \r\n
. Just remove the extra backslashes and you should be good to go.- Martin_SharrattDec 10, 2015NimbostratusThanks Brad, that's fixed the problem. I'm still a little concerned about how this happened though. The standby is at HF6 but the primary is still at HF3. Should upgrading one of a pair cause the configuration to be changed? If so, is there a way to stop this happening?
- Brad_Parker_139Dec 10, 2015NacreousAs soon as your standby syncs with the primary after rebooting those affected monitors will be updated on the primary as well. I would recommend turning off auto sync before you update the other device if it is on. After you reboot it do an overwrite config back to fix the broken monitors.